new gears for XT IP: 209.40.212.198 Posted on 7/17/2012 at 07:52:19 PM by Terry D
sorry Mack spent the money couple of yrs. back. Putten faster constant mesh,to the point where the input gear is bigger than the hole the trans came with. that beaing said ( even to notch out for teeth) might I grind some cast away from above the bearing area on inside of trans case to give me more room to work(like to hold input shaft further forward)? does the snapring on the bevelshaft have to be instaled? Did this project on the 21 a number of yrs back. not imposible but am getten older. ha ha good luck to all out there on your hooks. thanks in advance for your input. Replies: